Avancon logo

Compare which conveyor system you 

would prefer:

Old style and obsolete conveyor construction

Still today you will find such constructions. - It's hard to believe!

antique conveyor from 1950, old style and obsolete conveyor construction

Separated Guide screwed on the profiles.

Perforated steel-sheet profile with many holes. - Dust catcher!

All steel profiles were painted. - Claw marks are visible. Power elements (O-belts, V-belts, etc.) externally visible and not safe.

Photo-sensors mounted on top of the profiles - conveyed goods can be damaged. In case of accumulation, control-boxes are screwed on the U- or C-profiles. - Many cables have to be equipped and plug them into the sockets of the control boxes. - Time consuming, expensive!

“Spaghetti syndrome” of cables everywhere in U- or C-profiles. - High installation cost. Cables have to be fixed somehow. In case of long lines, very often separate cable channels are necessary to install at site.  

Legs are also made of perforated steel sheet profiles. - Full of dust after some time in use. In addition pneumatic lines for pneumatic devices are often necessary. Partly the profile is covered with a separate profile made of PVC...

Avancon’s profiles are made of fine anodized Aluminum, 

torsion resistant and aesthetic.

It combines all single profiles of earlier constructions in one.

The photo-sensors are mounted in a transparent and protected housing inside the profile frame.

All patented drive elements are installed inside the closed profile frames, absolutely safe - without any tools!

The wiring with ASi-Bus System, - also patented - , is simple, clean and straight and flexible, easy to maintain, fast to install and exchangeable when needed. The conveyor sections are completely assembled,  pre-programmed and tested in the factory (see Quality). The single conveyor section can then easily be installed at site - through "real plug-in", mechanically and electronically.

The avancon legs are made of smooth and aesthetically 

formed fine anodised Aluminum.

Nowhere sticks something out, not even a screw head.

This concept is patented worldwide in most industrialised countries.

clean and secure conveyor design, most modern conveyor, new conveyor, avant-garde conveyor, secure convoyor

Made for tomorrow

and 

beyond.

arrow

AVANCON SA

Via Campagna 27

CH-6595 Riazzino /Switzerland

phone: +41 (0)91 222 10 10

e-mail: relations(at)avancon.com

instagram
youtube
linkedin

© 2021 All Rights Reserved | AVANCON SA

vimeo

This site uses cookies, including third parties, necessary for its operation. If you click "ACCEPT" you consent to the use of third party cookies affected by the GDPR legislation. If you want to keep them deactivated click “NOT ACCEPTED”. If you disable them some functions of the site will be blocked. MORE INFORMATION

NOT ACCEPTED

ACCEPTED